Our New BentGrass
Putting Green Technology
revolutionized the old polypropylene fibers
and gives you the most realistic putting
green surface on the market today. We now
offer the only Pre-bent Non-directional ™
technology on the market today (thanks to
companies like BASF, Nova, & others).
This
Technology Has Several
benefits like
(a) tougher
fibers that are Pre-bent Non-directional ™
(b) easy
adjustable stimp speed
(c) better ball action
(d)
reduces putting green installation time by
better than half.
Pre-bent
Non-directional ™
- We start with
an approximate 5/8" - 1" fiber and then
we reduce it (pre-bend) to a 3/8" -
11/16" finished height by means of our
new manufacturing process. This ensures you
that the end results will be an actual well
dressed putting green surface that does not
require a seasoned installer.
Non-Directional Fibers
will never lean one direction like the old
technology. The leaning of the fibers will
cause a huge speed difference depending on
if you are putting against the grain or with
the grain. In the past, it has taken a
tremendous amount of effort
(labor and
know-how) to
eliminate this problem when using the old
polypropylene straight fiber putting green
material.
| |
Sample
Instructions:
Putting Green
Installation
 |
|
After rough cutting the
fringe material, put it in place and
nailing down the outer edge (use galvanized
6" or 7" gutter spike). Lift up the putting
green surface and place the fringe pieces under
the putting green surface. Now you can use the
putting green edge as a template to cut your
fringe. NOTE: Cut along the edge with a
good sharp utility
knife... Full
instruction info. available to customers, as
well as phone support.
|
